![]() The SoundFlower application from Cycling 74 is a "Free Inter-application Audio Routing Utility for Mac OS X". SoundFlower and a Digital Audio Link between the Mac and the HD hardware. In this case, Rewire is a good option, but there are two other options the user can try. The DAE engine in HD takes over the computer, and while Pro Tools is open, only allows PT to pass audio through the Digidesign hardware. All versions of Pro Tools HD currently do NOT offer a 'release audio' function. There is currently a range of Pro Tools HD audio hardware that does not allow 3rd party audio inputs when Pro Tools is running. Rewire Host) into the box in Revoice Pro Settings panel labelled Rewire Timecode Offset as shown in the example below with a 1 hour offset. Select the Revoice Pro View menu and select Settings as shown right.Ī Settings menu similar to that below should appear showing the current Rewire Timecode Offset which in the example is at zero.Įnter the amount of time displayed as the "Session Start" (or equivalent) offset in the Audio Editor (i.e. The effect of having a timecode offset between the host and Revoice Pro is that during playback, the timecode of the host will be offset from the timecode in Revoice Pro, and the audio playback will be out of sync by the offset amount. If your Audio Editor's Session Start timecode does not start at 0:0:0:0 (as shown, for example, in the Pro Tools Session Setup window below) you may have to apply a "Rewire Timecode Offset" in Revoice Pro. NOTE: Revoice Pro Scrubbing will not work with Rewire ON because the Host will not support it correctly.Your host (Audio Editor) application must be running in the same mode (32 or 64 bit.) Revoice Pro is a 32 and 64 bit application.(Revoice Pro currently installs Rewire Verison 1.8.2, build 127 - or higher) ![]() The correct version will be installed if required. An automatic check will be made to see if the correct version of Rewire is installed.To check for, or install rewire - run Revoice Pro and press the Rewire on/off button which is located as shown here in the red circle: Pro Tools, Logic, Cubase, Nuendo, etc.) is the Rewire Host Application (sometimes called "Mixer"). When using Rewire, Revoice Pro is the Rewire Source Application (sometimes called "Slave") and your Audio Editing software (e.g. This allows monitoring directly out of your audio hardware and synchronized playback with your Audio Editor.You can use Rewire to send audio from Revoice Pro into your Audio Editor. ![]() The menu shown right should appear and the user can use the Audio Output drop-down menu to chose the external Audio Hardware as shown (in this example, an Mbox 2 is being selected). Select the Preferences menu under Revoice Pro in the menu bar and make sure General is selected. This section does NOT apply to Pro Tools HD hardware, which is discussed separately below. Monitoring through External Audio Hardware The menu shown right should appear and the user can use the Audio Output drop-down menu to chose Built-in Output as shown. Monitoring through Mac built-in Audio Output This method is the simplest to set and use.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |